Be sure to install the half bracket with the open end at the top image 4.
Diy closet rod support.
2 locate a stud near the center of the closet rod or two studs equidistant to the center with a stud finder.
We placed the top of the rod 35 in.
Locate studs on the back wall of the closet with a stud finder.
If your existing closet rod is at least 66 in.
Measure your current closet rod s diameter and how far it hangs away from the wall.
From the floor which allowed just enough room to hang two levels of pants.
The closetmaid superslide closet rod end caps are the closetmaid superslide closet rod end caps are designed for use on the ends of closetmaid closet rods to prevent hangers from sliding off the end of the rod.
No matter the choice you make a closet rod will make a useful addition to other closet organization systems such as shelves drawers and hooks.
Locate studs on the back wall of the closet with a stud finder.
If your existing closet rod is at least 66 in.
In order to make the closet rod truly helpful put it at a height that makes it accessible and useful.
A double rod set up should have the bottom rod mounted at 3 5 feet 1 1 m and the upper rod mounted at 7 feet 2 1 m.
Closet rods come in a few different shapes including circular and oval options.
From the floor there s enough space to add a second rod below it and still hang shirts and slacks.
The easiest way to do the latter is to measure how long the current brackets are.
Watch this vid for an easy solution other than to not fill the closet with clothes.
Two inches should be suffice.
In general it s a good idea to mount a single rod at 5 feet 1 5 m tall.
A minimum of 10 inches is best but it ll depend on the size of your hangers.
Install the closet rod and top shelf support bracket.
Diameter rod to ease installation.
From the floor which allowed just enough room to hang two levels of pants.
We placed the top of the rod 35 in.
If the bracket is over a stud use screws.
Choose an appropriate height for the rod.
From the floor there s enough space to add a second rod below it and still hang shirts and slacks.
Install the closet rod end brackets on the marked locations of the existing wall cleats.
Once wall studs have been located closet rods and brackets can be screwed into the stud for optimal support.
Measure for the distance away from the wall.
This package contains 2 caps that have flanges and slide into the end of the 3 4 in.
If not use hollow wall anchors image 3.
Insert the closet rod and lay the top.