Do Prime And Paint Cut Ends Of Truwood Siding

Do not bevel cut the siding edges at butt joints.

Do prime and paint cut ends of truwood siding.

Once the siding has been installed apply two coats of a top of the line latex exterior house paint to it. 2018 2015 2012 2009 international. Therefore do not prime the back side of the siding or trim. Watch this video to find out more.

Roof and gutters are adjacent to the siding. If trim is cut to fit around door and window openings raw edges. I would strongly suggest priming the front back edges and ends of your pine siding with an oil based exterior primer before installation. Truwood siding meets the requirements of the following codes and standards.

According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate. Back priming helps prevent paint from peeling by reducing the amount of water vapor that passes through the wood. Spray cans or primer or disposable cans and brushes with primer can be used to prime the end grain once installed. Additional primer is not needed field painting guidance for best results with our primed siding products.

Make sure to prime and paint all exposed cut edges. Cutting cut with conventional tools into the face to be exposed. When back priming be sure to prime the ends of each piece after it has been cut to fit since end grain will absorb the most moisture. Do not miter sides edges of trim.

Make sure to prime and paint all cut edges. Use high quality waterborne 100 acrylic exterior paints apply a finish coat within 180 days of installation do not paint wet siding ensure the surface is clean dry and free of any dust dirt or mildew do not use. All it takes is a little can of paint or sealer. Do not paint in wet or cold conditions.

Clearance between the gutter end and trim see fig.