How to glue drywall to the interior of concrete block walls.
Drywall over cinder block wall.
The hat channel image 1 should be attached to the wall using concrete nails and concrete nail gun images 2 and 3.
First draw a plumb line to make sure the hat channels will be spaced properly for the size of drywall and insulation you re using.
Install vertical furring strips every 16 inches on the cinder blocks using concrete screws to hold them in.
Pick the chalk line up pulling it.
Cut the nozzle end of a tube of construction adhesive at a 45 degree angle using a utility knife.
Repeat for all drywall sheets.
Attach the drywall to the furring strips with a nail gun and one inch drywall nails.
Use concrete nails and a concrete nail gun to attach the hat channels to the wall after drawing a plumb line to make.
How to put drywall over cinder block step 1.
Add some rigid board insulation between the hat.
Stretch a chalk line from the first top mark down to the corresponding bottom mark.
Using a scraper scrape off chunks of debris from the wall to make it as smooth as possible.
Run a base furring strip along the bottom of the cinder block wall from end to end.
These correspond to the typical.
Poke the foil cover at the.
Frame out the rest of the wall by adding faux top and sole plates dropping the top a bit for a drop ceiling if.
Furring strips come in.
Measure across a wall both at the top and bottom.
Begin in an upper.
Drive three concrete nails spaced at even intervals through each side of each hat channel.